Question
Easy
Solving time: 1 mins
For wiring in the home, one uses wires or Al wires. What considerations are involved in this?
Found 3 tutors discussing this question
Discuss this question LIVE
14 mins ago
Text solutionVerified
The Cu wires or Al wires are used for wiring in the home.
The main considerations are involved in this process are cost of metal, and good conductivity of metal.
The main considerations are involved in this process are cost of metal, and good conductivity of metal.
Was this solution helpful?
125
Share
Report
One destination to cover all your homework and assignment needs
Learn Practice Revision Succeed
Instant 1:1 help, 24x7
60, 000+ Expert tutors
Textbook solutions
Big idea maths, McGraw-Hill Education etc
Essay review
Get expert feedback on your essay
Schedule classes
High dosage tutoring from Dedicated 3 experts
Practice more questions from Physics Exemplar (NCERT Exemplar)
Practice questions from Physics Exemplar (NCERT Exemplar)
Question 1
First a set of equal resistors of each are connected in series to a battery of emf and internal resistance current is observed to flow. Then, the resistors are connected in parallel to the same battery. It is observed that the current is increased 10 times. What is ''?Easy
Question 2
is a potentiometer wire (figure). If the value of is increased, in which direction will the balance point shift?Easy
Question 3
Let there be resistors with and . Show that when they are connected in parallel, the resultant resistance and when they are connected in series, the resultant resistance . Interpret the result physically.Medium
Practice more questions from Current Electricity
Question 1
When potential difference is applied across an electrolyte, then Ohm's law is obeyed atEasy
Question 2
At what temperature will the resistance of a copper wire become 6 times its value at (Temperature coefficient of resistance for copper )Medium
Practice questions on similar concepts asked by Filo students
Question 1
2.17: A car's velocity as a function of time is given by c(t) = a + 3t², where a = 3.00 m/s and b = 0.100 m/s³. (a) Calculate the average acceleration for the time interval t = 0 to t = 5.00 s. (b) Calculate the instantaneous acceleration for t = 0 and t = 5.00 s. (c) Draw v-t and a-t graphs for the car's motion between t = 0 and t = 5.00 s.
2.38: You throw a glob of putty straight up toward the ceiling, which is 3.60 m above the point where the putty leaves your hand. The initial speed of the putty as it leaves your hand is 9.50 m/s. (a) What is the speed of the putty just before it strikes the ceiling? (b) How much time from when it leaves your hand does it take the putty to reach the ceiling?
Name: x (m) 400 300 200 100 0 1 11 III 1 of 2 IV 1 2 3 4 5 6 7 8 (min) PHYC 201 Summer 2023 - Cuyamaca College Assignment 2 Figure 1: Problem 2.10
2.51: A rocket starts from rest and moves upward from the surface of the earth. For the first 10.0 s of its motion, the vertical acceleration of the rocket is given by ay = (2.80 m/s)t, where the +y-direction is upward. (a) What is the height of the rocket above the surface of the earth at t = 10.0 s? (b) What is the speed of the rocket when it is 325 m above the surface of the earth?
Question 2
'If you were carefully watching this planet during the entire orbit; would the speed of the planet be increasing; decreasing or staying the same? How do you know?'
Question 3
Consider the reversible ideal gas cycle illustrated above. AB and CD are isotherms. BC is isochoric (constant volume). Below represents the same cycle.
Question 4
If the following input signal is sent through a - junction diode, then the output signal will be
Stuck on the question or explanation?
Connect with our Physics tutors online and get step by step solution of this question.
231 students are taking LIVE classes
Question Text | For wiring in the home, one uses wires or Al wires. What considerations are involved in this? |
Topic | Current Electricity |
Subject | Physics |
Class | Class 12 |
Answer Type | Text solution:1 |
Upvotes | 125 |